U-Line 1175R - Manual (Page 21)

1115R, 1175R, 29R, 1175BEV 21
Figure 45
14. Fasten upper hinge to unit (three screws) (Figure 45).
Partially tighten screws until door is aligned.
15. Adjust door to assure proper seal. Tighten upper hinge
screws securely.
16. Replace three plastic plugs removed in Step 11 into
holes on top of unit. Replace screws in holes in bottom
of unit, opposite side.
17. Re-inspect door seal and alignment. Adjust if needed.
Figure 46
18. Make sure grille cap is behind grille in slots provided in
grille (Figure 46, 1) before attaching grille to unit, and
secure but do not overtighten both grille screws
(Figure 46, 2).
Door Shelf Removal/Insertion
Figure 47
NOTE: 1115R and 1175R models only
To remove the door shelf:
1. Grasp shelf in center, and lift until the shelf notches
(Figure 47, 1) clear the bosses (Figure 47, 2).
2. Carefully pull the shelf away from the door.
To install the door shelf:
1. Holding the shelf in the center, center the shelf in the
door at the desired location, slightly above the bosses
(Figure 47, 2).
2. Lower the shelf onto the bosses (Figure 47, 2).
ULIN_0143_A
ULIN_0198_A
2
1
1
2
ULIN_0040_A
ULIN_016357_30087.fm Page 21 Tuesday, March 14, 2006 2:36 PM