Uniden D1680-9 - Manual (Page 15)

1
To... From the base From a handset
delete a
message
While a message is playing, press
dElETE .
While a message is
playing, select 4:Delete .
delete all
messages
With the phone in standby,
press dElETE ; press dElETE again to
confirm.
Not available.
play old
messages
After the system plays all new messages,
press Play/sToP again. select 2:Play .
stop playback Press Play/sToP . Select 5:Stop .
Screening Your Calls
You can use the answering system for call screening. While the system
takes a message, you can listen on the base speaker (if you turn on Call
Screen) or from a handset. Only one handset can screen calls at a time. If
another handset tries to screen calls, it beeps and returns to standby.
To... From the base From a handset
hear the caller leaving
a message
Listen to the caller
over the speaker.
Press MEssagE/MuTE .
answer the call NA Press Talk/flash .
mute the call screen
without answering*
Press Play/sToP .
Press End or return the
handset to the cradle.
* If you mute the call screen, the system continues taking the message: it just
stops playing through the speaker.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone.
Before you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select
Ans. Setup , then select
Security Code . Use the number keypad to enter a two-digit security code
( 01 to 99 ). Press MEnu/sElEcT when you’re finished.
Remember to make a note of your new security code!
Dialing In to Your System
Call your phone number & wait until the system answers. (If the system
is turned off, it answers after 10 rings & sounds a series of beeps.)

1.