Uniden D1680-9 - Manual (Page 12)

1
Handset to Handset Intercom
Whenever the phone is in standby, you can make an intercom call
between handsets without using the phone line.
You can make an intercom call from any handset, but only two handsets
can be in an intercom call at any time.
If an outside call comes in during an intercom page, the phone cancels
the page so you can answer the incoming call.
If an outside call comes in during an intercom call, press
Talk/flash to
hang up the intercom call and answer the outside call.
To... Press...
make an intercom
page
inTErcoM/clEar. Select the handset you want to talk
with, or All to page all handsets at the same time.
cancel a page End .
answer a page inTErcoM/clEar or Talk/flash .
end an intercom call End . Both handsets return to standby.
Chain Dialing
If you often have to enter a series of digits or a code number during a
call, you can save that code number to a phonebook entry and use the
phonebook to send the code number.
Enter the code number (up to 20 digits) into the phonebook just like
a regular phonebook entry. Be sure to enter the code number into the
phonebook exactly as you would enter it during a call.
When you hear the prompt that tells you to enter the number, open the
phonebook and find the entry that contains your code number.
Press
MEnu/sElEcT to send the code. If you change your mind, just close
the phonebook.
Voice Message Notification
If you subscribe to a voice mail service, your phone can notify you when
you have a new message. This feature supports Frequency-Shift Keying
(FSK) notification. Contact your voice mail provider for information.
When you have new messages, the display shows a message icon. After
you listen to your messages, the message icon turns off. If it doesn’t, you
can reset it: With the phone in standby, open the menu and select Global
Setup ; select VMWI Reset , then select Yes.
♦
♦
♦
♦
1.
2.
3.
♦
♦