Uniden ANA 9710 - Manual (Page 8)

Important Safety Instructions
When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electrical
shock, and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a dry
cloth for cleaning.
4. Do not use this product near water; for example, near a sink
or in a wet area.
5. Do not place this product on an unstable cart, stand, or
table. The telephone may fall, causing serious damage to
the unit.
6. To protect the product from overheating, do not block or
cover any slots or openings in the base Unit. This product
should never be placed near or over a radiator or heat
register. This product should not be placed in a built-in
installation unless proper ventilation is provided.
7. This product should be operated only from the type of power
source indicated on the marking label.
8. Do not allow anything to rest on the power cord. Do not
place this product where the cord will be damaged by
persons walking on it.
9. Do not overload wall outlets and extension cords, as this
can result in the risk of fire or electrical shock.
10. Never put objects of any kind into this product through the
Base Unit slots, as they may touch dangerous voltage points
or short out parts that could result in a risk of fire or electric
shock. Never spill liquid of any kind on the product.
11. To reduce the risk of electric shock, do not disassemble this
product. Contact qualified service personnel when service or
repair work is required. Opening or removing covers may
expose you to dangerous voltages or other risks. Incorrect
reassembly can cause electric shock when the appliance is
subsequently used.
12. Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
A. When the power supply cord is damaged or frayed.
B. If liquid has been spilled on the product.
C. If the product has been exposed to rain or water.
2