Installation – Universal Remote Control (URS) RFX150 User Manual

Page 6

Page 3

MRF-300 B

ASE

TATION

Installation

Step 1 - Set the RF ID # rotary switch on the bottom of the MRF-300 to a
VALID ID# (any address other than ID# 0). If you leave it set to ID# 0, the MRF-300
operates with some restrictions:

a. Accepts RF signals from any 418MH

remote control regardless of

the address set when programming the remote control.

b. Front Blaster will be OFF and all IR line outputs are set to ALL).

Step 2 - Mount or place the MRF-300 conveniently and run flashers
to each component’s front panel sensor or connect the Line Out to
a components rear panel IR Input.

Slide off the mounting plate to reveal the RF ID# rotary switch. Use a small flat blade
screwdriver to set the RF ID# to the address you used when programming the remote
control (1-9 or A-F are valid addresses, while 0 is not a valid address).

MRF-300 Manual.qxd 1/14/2005 12:40 PM Page 3

This manual is related to the following products:

MRF-300