Uniden DECT1588 - Manual (Page 50)

50
Using the
Answering
System
To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:
1).Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.after.
about.ten.rings.and.sounds.a.series.of.beeps.
2).During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.0.and.enter.your.security.code/PIN.within.
two.seconds.
3).The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..
You.hear.“To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero”.followed.by.a.beep.
4).Enter.a.remote.command.from.the.chart.below..You.have.fifteen.seconds.to.enter.the.first.command;.after.the.
first.command,.you.have.two.seconds.to.enter.each.command.
If you want to Press If you want to Press
Play.incoming.
messages
0.then.2.
The.answering.system.plays.back.
messages.for.four.minutes,.then.
waits.for.another.command..To.
continue.playing.your.messages,.
press.0.then.2.again.
Stop.the.current.operation.to.
enter.a.different.command.
0.then.5
Repeat.this.message. 0.then.1.(after.the.first.four.
seconds.of.this.message)
Turn.the.answering.system.off 0.then.9
Go.back.to.the.
previous.message
0.then.1.during.the.first.four.
seconds.of.a.message.
Turn.the.answering.system.on 0.then.6
Skip.this.message 0.then.3 Listen.to.the.help.prompts 1.then.0
Delete.this.message 0.then.4 Exit.the.system Hang.up.
5).When.you.finish,.you.will.hear.intermittent.beeps.indicating.that.the.system.is.in.the.command.waiting.mode..
Enter.another.command.from.the.chart.within.fifteen.seconds.
6).Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.