Uniden D1685 User Manual
Page 20
English - 20
Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone line
from causing interference on your phone. To get a line filter, contact your
service provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter.
Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter &
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off
and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that the vent
faces down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers & reconnecting cords.
Resetting Stations
Unplug the base to reset it. Plug it back in after at least a minute.
If you have trouble with a handset or if you want to replace one, reset it.
1. Press & hold
End
and
#
at the same time until you see the
System Reset
menu.
2. If you still have the base the handset is registered to, select
Deregister
HS
, then select the handset you want to reset. If you don’t have that base
anymore, select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
Registering Handsets
If you see
Not Registered
on a handset, you must register it to a base before use.
1. Place the handset in the base; the display should say
Registering
. If the
handset does not fit in the base, open the base menu and select
Register Accy
.
On the handset, press and hold
#
until
Registering
displays.
2. Wait until the display says
Registration Complete
(about 30 seconds), then
pick up the handset and press
Talk/Flash
.
#
If you don’t hear a dial tone or the display says
Registration Failed
,
charge the battery completely, then try again.