Uniden D1685 - Manual (Page 17)

English - 17
To... From the base From a handset
replay an earlier
message
During the first 2 seconds of a message,
press PhonEbook. select 1:Repeat .
skip a message Press cId . Select 3:Skip .
delete a
message
While a message is playing,
press dElETE . select 4:Delete .
delete all
messages
With the phone in standby, press
dElETE ; press dElETE again to confirm. Not available.
play old
messages
After the system plays all new messages,
press PlaY/sToP again. select 2:Play .
stop playback Press PlaY/sToP . Select 5:Stop .
Screening Your Calls
You can use the answering system for call screening. While the system takes a
message, you can listen on the base speaker (if you turn on Call Screen) or from
a handset. Only one handset can screen calls at a time. If another handset tries
to screen calls, it beeps and returns to standby.
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller over
the speaker.
Press MEssagE/MuTE .
answer the call Press sPEakEr . Press Talk/Flash .
mute the call screen
without answering*
Press PlaY/sToP .
Press End or return the
handset to the cradle.
* If you mute the call screen, the system continues taking the message: it just stops
playing through the speaker.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone. Before
you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select Ans. Setup , then select
Security Code . Use the number keypad to enter a two-digit security code ( 01 to
99 ). Press MEnu/sElEcT when you’re finished.
#
Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number & wait until the system answers. (If the system is
turned off, it answers after 10 rings & sounds a series of beeps.)