Uniden DSS8955+3 - Manual (Page 67)

66
One
Year Limited W
arranty
ONE YEAR LIMITED WARRANTY
UNIDEN DSS8955, DSS8955+1, DSS8955+2 and DSS8955+3
IMPORTANT :
Evidence of original purchase is required for
warranty service.
WARRANTOR : Uniden Australia Pty Limited
A.B.N. 58 001 865 498
Uniden New Zealand Limited
Warranty only available in original country of purchase.
ELEMENT OF WARRANTY :
Uniden warrants to the original retail owner for the duration of this
warranty, its DSS8955, DSS8955+1, DSS8955+2 or DSS8955+3
(herein after referred to as the Product), to be free from defects in
materials and craftsmanship with only the limitations or exclusions
set out below.
WARRANTY DURATION:
This warranty to the original retail owner only, shall terminate and
be of no further effect ONE (1) year after the date of original retail
sale. This warranty will be deemed invalid if the Product is;
(A) Damaged or not maintained as reasonable and necessary,
(B) Modified, altered or used as part of any conversion kits,
subassemblies, or any configurations not sold by Uniden,
(C) Improperly installed,
(D) Repaired by someone other than an authorized Uniden Repair
Agent for a defect or malfunction covered by this warranty,
(E) Used in conjunction with any equipment or parts or as part of a
system not manufactured by Uniden, or
(F) Where the Serial Number label of the product has been
removed or damaged beyond recognition.
Warranty only valid in the country of original retail/sale.
PARTS COVERED:
This warranty covers for one (1) year, the Product and included
accessories.
STATEMENT OF REMEDY:
In the event that the Product does not conform to this warranty
at any time while this warranty is in effect, the warrantor at its
discretion, will repair the defect or replace the Product and return it
to you without charge for parts or service. This warranty does not
provide for reimbursement or payment of incidental or consequential
damages.
This EXPRESS WARRANTY is in addition to and does not in any
way affect your rights under the TRADE PRACTICES ACT 1974
(Cth) (Australia) or the CONSUMER GUARANTEES ACT (New
Zealand).
PROCEDURE FOR OBTAINING PERFORMANCE OR
WARRANTY:
In the event that the Product does not conform to this warranty,
the Product should be shipped or delivered, freight pre-paid, with
evidence of original purchase (e.g. a copy of the sales docket), to
the warrantor at:
UNIDEN AUSTRALIA PTY LIMITED
SERVICE DIVISION
345 Princes Highway, Rockdale NSW 2216
Fx(02) 9599 3278
www.uniden.com.au
UNIDEN NEW ZEALAND LIMITED
SERVICE DIVISION
150 Harris Road, East Tamaki, Auckland
Fx(09) 274 4253
www.uniden.co.nz
Customers in other States should ship or deliver the Product freight
pre-paid to their nearest Uniden Authorized Repair Centre
(Contact Uniden for the nearest Warranty Agent to you).
DSS8955 OM.indb 66 28/7/08 5:21:06 PM