Uniden DSS8955+3 - Manual (Page 15)

13 14
Installing the Phone
Place the mounting
slots over the pins
on the wall plate.
Slide the base
down to lock it
into place.
Wall plate
At the bottom of the base, lift up on
the release latch between the two
bottom tabs and push the bracket up.
Removing the wall-mount bracket
(To AC outlet)
Release latch
Note: Mounting the phone directly on the wall
Be sure the wall is capable of supporting the weight of •
the phone, and use the proper type of anchoring device
for the wall material.
Insert two #10 screws (minimum length of 35mm, not •
supplied) into the wall, 100mm apart.
Leave the screw heads 3mm away from the wall to •
allow room for mounting the phone.
Align the mounting slots over the screws and slide the •
base down into place as shown above.
DSS8955 OM.indb 14 28/7/08 5:20:44 PM