Uniden DSS8955+3 - Manual (Page 47)

46
Using the
Answering
System
Using the Answering System
Turning Your Answering System On and Off
From the base From the handset
Turning On
With the phone in standby, press 1)
[ answer on/off].
The system announces “Answering System
2)
is on” and plays the current greeting.
ANSWER ON appears on the base display.
3)
Press 1) [menu/select].
Select the ANSW. SETUP menu, and then 2)
the ANSWER SETUP submenu.
Move the cursor to select ON.
3)
Press 4) [menu/select]. You will hear a
confirmation tone.
Turning Off
With the phone in standby, press 1)
[ answer on/off].
The phone announces “Answering System
2)
is off.”
ANSWER OFF appears on the base display.
3)
Press 1) [menu/select].
Select the ANSW. SETUP menu, and then 2)
the ANSWER SETUP submenu.
Move the cursor to select OFF.
3)
Press 4) [menu/select]. You will hear a
confirmation tone.
Note: If the answering system announces “No remaining time” when you turn it on, the memory is full (the message
counter also shows FL). The answering system can’t record any new messages until you delete some of the
saved ones.
DSS8955 OM.indb 46 28/7/08 5:21:02 PM