Unified Brands HYPERSTEAM HY-6G(CE) - Manual (Page 13)

OM/SM-HY-6G(CE) 1
OM/SM-HY-6G(CE)
13
The process for de-liming your HY-6G (CE) Steamer is simple,
tool-less and quick.
6.2.2 Steam Generator and Cooking Chamber
The steamer cavity and steam generator may be
cleaned separately. When cleaning is scheduled, or
if the SERVICE light is on, follow these simple de-
liming instructions. REMEMBER: DON’T ALLOW
DE-LIMING AGENTS TO MIX WITH DE-
GREASERS.
1. Set the timer to OFF position.
2. Turn off the steamer for five
minutes.
3. Open the door and allow the
cavity to cool.
4. After the cavity has cooled five minutes, make
sure that the fan has stopped and remove the
fan baffle partition by lifting it up and toward the
center of the cavity.
5. Wipe out the cavity. Make sure the drain holes
at the back of the cavity are clear of debris.
6. Hold down the CLEAN button while turning the
steamer on. Continue holding it
until the CLEANING indicator light
comes on. Then release the
button. After five minutes, the
beeper will begin to beep rapidly.
This is the signal to add 500 ml per
cavity of Groen De-limer De-
Scaler (P/N 114800), Lime-A-Way® or
equivalent as shown at right. Do not use any de-
limer that contains chlorine.
7. Replace fan baffle partition and close door.
8. The cleaning cycle consists of a boiling clean
stage, a soak stage, and a rinse stage. The full
cycle takes about 50 minutes to complete.
9. WEAR PROTECTIVE GLOVES AND EYE
PROTECTION FOR THIS
STEP. When the steamer
beeper sounds, turn off the
steamer and open the door.
After the fan has stopped,
remove the fan baffle partition
and rinse it well in a sink.
Wipe out the cavity
completely. If necessary, use a damp nylon pad.
10. Reinstall the fan baffle.
11. If the steamer will no longer be used, leave it off.
Otherwise, wait 10 minutes and turn it back on.
When the READY light comes on, the steamer is
ready for operation.
6.2.3 If the SERVICE light stays on:
1. Check that the water supply is on and that the
supply hose is not kinked. With the problem
corrected, turn the steamer off or 10 seconds
and then re-start.
2. Repeat steam generator cleaning.