Toshiba TEC EM1-33046A - Manual (Page 30)

13. GENERAL MAINTENANCE EM1-33046A
13.2 COVERS AND PANELS
13.2 COVERS AND PANELS
The covers should be cleaned by wiping with a dry cloth or a cloth slightly dampened with a mild detergent
solution.
NOTE: Clean printer cover with an electrostatic free cleaner for automated office equipment.
WARNING!
1. DO NOT POUR WATER directly onto the printer.
2. DO NOT APPLY cleaner or detergent directly onto any cover or panel.
3. NEVER USE THINNER OR OTHER VOLATILE SOLVENT on the plastic covers.
4. DO NOT clean the panel covers or the supply window with alcohol as it may cause them to
discolor, loose their shape or develop structural weakness.
13.3 REMOVING JAMMED MEDIA
1. Turn the power off.
2. Open the printer cover.
3. Open the printer carriage by pulling up the release lever on the forward left side of the front rubber
roller.
4. Remove the ribbon and media.
5. Remove the jammed media. DO NOT USE any sharp implement or tool as these could damage the
printer.
6. Clean the print head and front rubber roller, then remove any further dust or foreign substances.
7. Media jams in the cutter unit can be caused by wear or residual glue from label stock on the cutter.
Do not use unspecified media in the cutter. If you get frequent jams in the cutter contact your
Authorized Service representative.
13-2
13.4 DENSITY ADJUSTMENT
Density adjustment may be necessary according to the temperature of environment in use.
(Reference: Interface Command Manual)