Technicolor - Thomson MS4300 - Manual (Page 7)

Unpacking the system
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one FM antenna;
• one AM loop antenna;
• one user’s guide;
• one Thomson Warranty Card
Back View
1. AM Loop antenna Jacks.
2. FM Antenna Connector.
3. Main Speaker Jacks.
4. Aux In.
Using the FM and AM Antennas
Before you use your audio system, you’ll want to
make sure both the FM and AM antennas are
positioned properly. Connect the FM antenna to
the FM connector on the back of the unit. Uncoil
it, making sure it is fully extended. (you may even
want to tape it to the wall behind the unit if
possible. The higher the better.)
You’ll also need to connect the AM antenna loop
to the back of the unit if you listen to AM
stations. Rotate the AM loop antenna for better
reception.
Connecting the Speakers
Match the red wire (on the left speaker) to red
terminal for the left speaker (L) on the back of
the unit and the black wire (on the left speaker )
to the black terminal for left speaker (L). Follow
the same procedure to connect the right (R)
speaker.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
2
EN
Getting Started
CLOCK
DISC 1 DISC 2 DISC 3 DISC 4 DISC 5
TIMER RECORD PROG/SET DEMO BAND/ AUTO PROG
ON/ECO SOURCE
VOLUME
PRESET
TUNE/PRESET
CD-R / RW COMPATIBLE 5 DISC CHANGER
C D
TU NER TAPE
A U X
R O C K PO P JAZZ CLAS SIC CU ST O M
D I S C N U M B E R
+ -
mp3
CD INFO
10 cm
10 cm
Front View
10 cm
10 cm
5 cm
Side View
R L
MAIN SPEAKERS 6
Ω
R L
+ + AM LOOP
FM 75 Ω
A UX IN
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Speaker Wire Connection
Push Speaker terminal tab
down to insert wire.
1
2
3
4
MS4300 EN 3/9/05 4:33 PM Page 8