Technicolor - Thomson MS4300 - Manual (Page 11)

CD / TUNER / TAPE / AUX - indicates which
mode the unit is currently at.
- Timer is activated.
SLEEP - Sleep is activated.
- Random playback is activated in CD mode.
mp3 - mp3 indicator.
- Currently in playback mode.
INTRO - In CD mode, intro is activated so the first
10 seconds of each track will be played.
REPEAT 1 / REPEAT 1 DISC / REPEAT ALL DISC /
ALL DISC - In CD mode, indicates the repeat
option that is activated.
REPEAT 1 - Repeat track.
REPEAT 1 DISC - Repeat current disc.
REPEAT ALL DISC - Repeat all disc.
ALL DISC - Play all discs once.
FM / MW / LW - Radio band in tuner mode.
MHz / kHz - Radio frequency unit in tuner mode.
ST - In FM tuner mode, indicates stereo sound is
selected.
RDS - RDS signal detected in tuner mode.
PROG - In program mode.
REC - In tape mode, indicates tape is recording.
BASS BOOST - X bass is activated.
FLAT / ROCK / POP / JAZZ / CLASSIC / CUSTOM
- The preset equalizer currently selected.
VOL - Volume level indicator.
DISC 1,2,3,4,5 - The corresponding disc icon
lights to show which disc compartment is loaded.
The current playing disc will flash.
6
EN
General Controls
mp 3
C D
TU NER TAPE
A U
X
R O
C K
POP
JAZZ CLA
SS IC
CU
ST
O
M
D
I S
C N U M
B
E
R
Display
Installing Batteries
The remote control must be inserted with 2
"AAA" or "UM-4" or "R03" batteries prior to use.
Follow the steps below to ensure correct
installation.
1. Remove the battery compartment door
(located at the back of the remote control) by
sliding the compartment door in the direction
of the arrow and then lifting the door out and
off the cabinet.
2. Before inserting the batteries, observe the
polarities (that is, + and -) of the battery, then
relate the polarities to the engraved diagram
inside the battery compartment. Now insert
the batteries.
3. After installation of the batteries, replace the
battery compartment door in place by sliding it
in the opposite direction of the arrow (the
reverse of step 1).
MS4300 EN 3/9/05 4:33 PM Page 12