Thermador PGR48 - Manual (Page 5)

GAS AND ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
SECTION ONE: GENERAL SAFETY INSTRUCTIONS
SAFETY
SAVE THESE INSTRUCTIONS
It is the personal responsibility and obligation of you, the user, to have
this appliance connected to the electrical power supply in accordance
with the National Electrical Code and/or applicable local codes and
ordinances by a qualified electrician.
See Installation Instructions for electrical requirements and
grounding instructions.
ALWAYS DISCONNECT THE
ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
It is recommended that a
dedicated circuit servicing this
appliance be provided.
The use of gas cooking appliances
results in the production of heat
and moisture.
Gas Models:
PGR304
120 volts, 60 Hz.,
10 Amp electrical circuit required.
Gas Models:
PGR364GD, PGR364GL,
PGR366
120 volts, 60 Hz.,
10 Amp electrical circuit required.
Gas Models:
PGR486GD, PGR486GL,
PGR484GG
120 volts, 60 Hz.,
10 Amp electrical circuit required.
PLEASE READ CAREFULLY
If for any reason a gas control knob is turned ON and there is no
electrical power to operate the electronic igniters on the cooktop
burners, turn OFF the gas control knob and wait 5 minutes for
the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners manually, carefully hold a lighted
match to the burner ports and turn the gas control knob to HI.
During a power failure you can use the cooktop burners, but each
must be lit with a match.
DO NOT attempt to light the two left burners manually. These
burners are equipped with the ExtraLow
® feature and cannot be
lit manually.
CAUTION - ALL MODELS
IN CASE OF AN ELECTRICAL FAILURE
FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE
CONNECTED TO A
PROPERLY GROUNDED
AND
POLARIZED ELECTRICAL
POWER SUPPLY.
Page 3
TESTED IN ACCORDANCE
WITH:
• ANSI Z21.1 current issue for
Household Gas Appliances
• UL858 current Edition for
Household Gas Ranges
• CAN/CSA-22.2 No. 61-M89
for Household Cooking
Ranges
• CAN/CGA 1.1-M81 Domes-
tic Gas Ranges
Check your local building codes
for the proper method of installa-
tion. In the absence of local codes,
this unit should be installed in ac-
cordance with the National Fuel
Gas Code No. Z223.1 Current
Issue and the National Electrical
Code ANSI/NFPA No. 70 Current
Issue or the Can - B149 Installation
Codes for Gas Burning Appliances
and C22.1 Canadian Electrical
Code Part 1.
Accessible parts may
become hot when the grill
is in use. Young children
must be kept away.
CAUTION