Tanita TBF-560 - Manual (Page 18)

17
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
1. Turn on the power
Use the Orange Set button to
turn the unit on. The numbers
(1-2-3-4-5) will appear and the
display will flash.
2. Select the PERSONAL key
requiring height change
Use the Green Up/Down buttons to
select the PERSONAL key number
(which is number 4 in the example
shown above) for the person whose
height setting needs to be changed.
Then press the Set button. Then, the
preprogrammed year of birth (83, in
the example shown above) will
appear and the display will flash.
3. Confirm the year of birth
Since no change is needed on the
year of birth, press the Set button
to confirm it. The year of birth
will stop flashing. Then, the pre-
programmed month of birth (May,
in the example above) will appear
and the display will flash.
Changing height data for growing children
Follow this procedure to use a PERSONAL key that was previously programmed for another person.
Note: If birth date is changed at any time, the unit will assume the personal key is being reprogrammed for another user and will erase
any recorded measurements. Simply confirm birth year, month and date by pressing the Set button and continue on to adjust the height.
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
4. Confirm the month
and day of birth
Since no change is needed on the
month of birth, press the Set button
to confirm it. The month of birth
will stop flashing. Then, the prepro-
grammed day of birth (12th day, in
the example shown above) will
appear and the display will flash.
Since no change is needed on the
day of birth, press the Set button to
confirm it. The day of birth will stop
flashing. Then, the preprogrammed
height (4’1.5” in the example shown
above) will appear and the display
will flash.
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
5. Change the height
Use the Up button to change the
height (increased to 4’ 2.5” in the
example shown above). Then press
and hold the Set button until 2
“beeps” are heard. The confirmed
data will flash and the power will
shut off automatically.
!