Tanita TBF-560 - Manual (Page 14)

13
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
lb
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
lb
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
MALE
FEMALE
WEEK
MONTH
ATHLETE
TIME
DATE
DOB
lb
2. Unit does not record
measurements due to a
significant weight change
If the change in body weight is more
than the previous weight multiplied
by 1/16, the unit will not record the
measured values even if the Set
button is pressed to record. “No”
will flash in the display.
4. Availability of previously
recorded data
An arrow pointing to “WEEK” will
flash, to indicate the availability of
comparisons with previously
recorded measurements.
1. Turn on the power
and take measurement
Using your toe, tap the PERSONAL
key that has your preprogrammed
data. Wait for “0.0 lb” to appear
before stepping on the platform. Be
sure that your toes and heels are
correctly aligned with the toe and
heel electrodes on the measuring
platform. The unit will measure
the values of body weight and body
fat percentage (149.8 lb and 21.3%,
respectively, in the example
shown above).
Note: The unit will record the values of body weight and body fat percentage only once for a
certain date. If a person takes measurements several times a day, only the last values of body
weight and body fat percentage will be recorded for the day within that 24 hour period.
Overriding recorded data protection feature
If another person’s PERSONAL key is selected by mistake and a measurement is taken, then incorrect data could be recorded to
that PERSONAL key. In order to avoid this, when the unit detects a large weight change (of more than the previous weight multi-
plied by 1/16 ) within a two week period, the display will show “No” and will not measure. However, if a person has had a large
weight change during this period of time, and wants to record the new measurement, follow the procedure below.
3. Reconfirm PERSONAL key
and record measurement
Reconfirm that you are using your
PERSONAL key, then measure again
within 1 minute. Press the Set but-
ton. “No” flashes in the
display. Then press the Set button
again within 5 seconds. The unit will
make two “beeps” to indicate that
the measurement was recorded this
time.