TOA Electronics N-CC2564 - Manual (Page 4)

4
When Installing the Unit
• To avoid electric shocks, be sure to switch off the power before power supply wiring work. Failure to do so
may result in electrical shock.
• Leave the installation of the unit to your TOA dealer because the installation requires expert experience and
skills. If the unit falls, this could cause personal injures.
When the Unit is in Use
• Do not stand or sit on, nor hang down from the unit as this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
• Switch off the power, and unplug the power supply plug form the AC outlet for safety purposes when
cleaning or leaving the unit unused for a long period of time. Doing otherwise may cause a fire, burn injury or
electric shock.
• Have the unit checked periodically by the shop from where it was purchased. Failure to do so may result in
corrosion or damage to the unit or its mounting brackets that could cause the unit to fall, possibly causing
personal injury.
• Contact your TOA dealer as to the cleaning. If dust is allowed to accumulate in the unit over a long period of
time, a fire or damage to the unit may result.
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage. CAUTION
Note
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Modifications
Any modifications made to this device that are not approved by TOA Corporation may void the authority
granted to the user by the FCC to operate this equipment.
CU version complies with Part 15 of the FCC Rules.
2. LIST OF INCLUDED COMPONENTS AND PARTS
Check to be sure that the following components and parts are contained in the package:
Safety wire ......................................................................................................................... 1
Camera mounting screw (M4 x 8) ..................................................................................... 4
Category5 shielded coupler (female to female) ................................................................. 1
Extension connector (alarm input, AUX Contact output) .......................................... each 1
CD-ROM (Software decoder : N-SD2000, Manual (PDF)) ............................................... 1
Network Combination Dome Camera Installation Manual ................................................. 1
Software License Agreement ............................................................................................ 1
Network Camera System Installation Guide ...................................................................... 1
Note
The CD-ROM contains the Software Decoder, Software Decoder's Instruction Manual, Setting Manual,
N-DR2000 Status Monitoring Software, Instruction Manual and Installation Guide for N-DR2000 Status
Monitoring Software, Firmware, Adobe Acrobat Reader and DirectX.