TOA Electronics N-CC2564 - Manual (Page 25)

25
Camera
direction
Footing
M4 x 8 machine screw
(supplied with the
Network Combination Dome Camera)
Use screws M3 x 8
tightened to the base unit.
Camera direction
Secure these two holes first.
(Base unit mounting holes)
Suspension pipe
mounted to the ceiling. Saddle bracket
Oval hole
Screw
10. Attach two saddle brackets to the suspension pipe.
• Align the screw installed in the saddle bracket with the hole in the pipe.
• Attach the saddle bracket so that the orientation of its oval holes is as shown in the figure.
Note: Ensure that the saddle brackets are securely fixed without any play.
11. Attach the supplied safety wire to the base unit.
12. Attach removed footings to the base unit.
• First fix two of the base unit mounting holes as shown below.
• Use the screws supplied with the Network Combination Dome Camera.