Top Innovations SF-226 - Manual (Page 7)

7 Top Innovations, Inc.
A
SSEMBLING THE
H
ANDHELD
S
TEAM
C
LEANER
CONNECTING JET NOZZLE / WIDE NOZZLE
WARNING: DO NOT attempt to connect any accessories while unit is emitting steam. Doing
so could result in burns or other injury.
1. Insert cylinder on back of Jet Nozzle or Wide Nozzle (FIGURE 1) into opening of Steam Nozzle
(FIGURE 2). Align it so that two tabs on sides of cylinder (FIGURE 1-A) fit into two tab holes
on sides of opening (FIGURE 2-B). Be sure to push accessory in as far as possible.
2. Rotate Jet Nozzle or Wide Nozzle in a clockwise direction as indicated below (FIGURE 3-A).
Twist until you feel it “lock” into place and it will move no further. Note that single guide line on
top of Steam Nozzle aligns between dual guide lines on Jet Nozzle / Wide Nozzle (FIGURE 3-B).
FIGURE 1 FIGURE 2
FIGURE 3
A B
A B