Perreaux SILHOUETTE SXV1 - Manual (Page 22)

22
10 10 Troubleshooting Guide
Please use this guide if you are experiencing any problems with
the SXV1 in your system. It will provide possible solutions for
some given symptoms.
There is a
crackling
noise
coming from
my speakers
Output signal is clipping
The SXV1 gain setting is too high. Confirm that the gain is
configured correctly for your cartridge. If you are unsure,
decrease the gain setting step by step until the crackling noise
goes away.
Note: Ensure you switch the unit off before adjusting the DIP
switches.
Dust on needle and/or record
Make sure that your needle and record are free from dust and
debris.
I turn up the
volume but
it isn’t very
loud
Output level is too low
The SXV1 gain setting is too low. Confirm that the gain is
configured correctly for your cartridge. If you are unsure,
increase the gain setting step by step until the volume level is
suitable.
Note: Ensure you switch the unit off before adjusting the DIP
switches.
Incorrect cartridge loading
The resistive and capacitive cartridge loading configurations are
not set correctly. Check that these settings match the
requirements of your cartridge.
There is no
output from
my system
SXV1 not turned on
Make sure the SXV1 power switch is in the DOWN position.
AC cord not plugged in
Check that the AC cord is plugged into the IEC socket on the rear
of the SXV1.
Mains power not turned on
Check if the power is turn on at the mains socket on the wall.