Tripp Lite 93-2879 - Manual (Page 15)

15
If you are installing your Console Server Management Switch in a rack you will need to attach
the rack mounting brackets supplied with the unit, and install the unit in the rack. Take care to
head the Safety Precautions
Connect your Console Server Management Switch to the network, to the serial ports of the
controlled devices, and to power as outlined below
2.1.2 Kit components: B092-016 Console Server with PowerAlert
B092-016
Console Server with PowerAlert
2 x Cable UTP Cat5 blue
Connector DB9F-RJ45S straight and DB9F-
RJ45S cross-over
AC power cable
Quick Start Guide and CD-ROM
Unpack your Console Server and verify you have all the parts shown above, and that they all
appear in good working order
If you are installing your Console Server in a rack, you will need to attach the rack mounting
brackets supplied with the unit, and install the unit in the rack. Take care to heed the Safety
Precautions listed earlier
Proceed to connect your B092-016 to the network, to the serial and USB ports of the controlled
devices, to any rack side LCD console or KVM switch, and to power as outlined below
2.2
Power connection
2.2.1 Power: Console Server Management Switch
The B096-048/16 Console Server Management Switch has dual universal AC power supplies with auto
failover built in. These power supplies each accept AC input voltage between 100 and 240 VAC with a
frequency of 50 or 60 Hz and the total power consumption per Console Server is less than 30W. Two IEC
AC power sockets are located at the rear of the metal case, and these IEC power inlets use conventional
IEC AC power cords. A North American power cord is provided by default. Power cords for other regions
are available separately from Tripp Lite.