Tyco Electronics LD9000 Series - Manual (Page 9)

Specifications
Sensor
SecuGen FOR
Image Capture Speed 600ms/frame
Image Transfer Speed 500Byte/ms
Pixel Resolution 356x292
USB Signaling Type Full Speed Type
Theory of Operation
The USB host initiates communication with the FDU01 using operation commands
(Sensor LED On, Fingerprint Capture Start and Stop). Fingerprint data are then cap-
tured by the CMOS sensor at a total image size of 356 x 292 with 8-bit gray level. The
image frame transfer speed is 500 bytes/ms. It takes about 600 milliseconds to send one
frame of image data over USB protocols. FDU01 uses the SecuGen FOR (Fingerprint
Optic Reader).
Sensor Specifications
Sensor CMOS Image Sensor
Resolution 500dpi
Verifying Time <1sec
Image Capture Error Rate <0.1%
Life Time Typically 40,000Hrs
Credit Card Reader
There is a USB credit card reader only. The USB version is available in HID and Key-
board emulation versions. The reader reads all three stripes on a standard credit card or
drivers license.
Reference Standards-Conform to International Standards Organization, American National Standards
applicable standards Institute, California Drivers License, American Association of Motor
Vehicle Administrators
Message Format ACCII
Card Speed 3 to 50 IPS
MTBF Electronics 125,000 hrs; Head 1,000,000 passes
Barcode Scanner
Omni-directional scanner:
1. Ability to read 1D codes with a 360º rotation, eliminating the need to orient the
scanner in the field of view
2. Scan angle
Minimum horizontal: 34º ± 1.5º
Minimum vertical: 12.5º ± 1.5º
3. Ability to read 2-D barcodes (PDF417, Micro PDF)
4. Ability to read damaged or poorly printed barcodes
1-4 Elo Touchmonitor User Guide