beautypg.com

Tyco Electronics LD9000 Series User Manual

Page 142

background image

4

Serial Interface Pass-thru Models Installation

1 Mount the pole display to the metal base plate using the

mounting hardware provided.

2 The pole display can be used in a freestanding mode or

attached to the counter using the remaining mounting

hardware.

3 Connect the DB25M connector to the peripheral device or a

serial pass-thru terminator (optional accessory). Turn on power

of the peripheral device.

4 Connect the DB9F connector to the computer’s serial COM1 or

COM2 port.

5 Connect the female phone jack of the power adapter to the

male phone jack of the pole display cable.

6 Plug the power adapter into a 120VAC outlet.

7 A start up text message (LOGIC CONTROLS POS

COMPONENTS) will be present for a short time. When this

message disappears the cursor will be displayed at the left-

most digit of the top row.

Parallel Interface Pass-thru Models Installation

1 Mount the pole display to the metal base plate using the

mounting hardware provided.

2 The pole display can be used in a freestanding mode or

attached to the counter using the remaining mounting

hardware.

3 Connect the DB25F connector to the peripheral device or

parallel pass-thru terminator (optional accessory). Turn on

power of the peripheral device.

4 Connect the DB25M connector to the computer’s parallel

printer port (LPT1).

5 Connect the female phone jack of the power adapter to the

male phone jack at the DB25M/DB25F connector.

6 Plug the power adapter into a 120VAC outlet.

7 A start up text message (LOGIC CONTROLS POS

COMPONENTS) will be present for a short time. When this

message disappears the cursor will be displayed at the left-

most digit of the top row.

This manual is related to the following products: