Toshiba 50HX81 User Manual

Page 16

Intr

oduction

Connecting

our T

Using the

Remote Contr

Setting up

our T

Using the T

’s

eatur

Appendix

Index

Verifying the device code (990)

Use this feature to verify the codes for your other devices. The
number of blinks after pressing the 1, 2, 3, and 4 buttons is the 4-
digit code set up for that mode.
For example, to verify the device code of the VCR:

1. Press MODE to select the VCR mode.
2. While holding down the RECALL button, press 9 –9 –0.
3. Press 1

➝ 0 blinks.

4. Press 2

➝ 3 blinks.

5. Press 3

➝ 8 blinks.

6. Press 4

➝ 5 blinks.

This verifies that the device code of the VCR mode is “0385.”

Using the volume lock feature (993)

For the TV, CABLE/SAT, VCR, and DVD modes, the volume
controls (VOL

yz and MUTE) can be programmed (locked) to the

selected device mode. This feature does not apply to the AUDIO1/2
modes.
For example, to lock the volume controls to always jump to the
CABLE/SAT mode:

1. Repeatedly press MODE to select the CABLE/SAT mode.
2. While holding down the RECALL button, press 9 –9 –3.
3. Press VOL

The Mode indicator will blink two times (locked).

The following table describes in more detail the Volume Lock
implementation.

Volume

CBL/SAT

VCR

DVD

AUD1 AUD2

Locked to
TV (default) TV

AUD1 AUD2

CBL/SAT

CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2

VCR

AUD1 AUD2

DVD

AUD1 AUD2

AUD1

AUD1 AUD1

AUD2

AUD2 AUD2

To reset the volume controls to the original device code:

1. While holding down the RECALL button, press 9 –9 –3.
2. Press VOL

The Mode indicator will blink four times (unlocked).

Operational feature reset (980)

This feature clears all setup features not related to “Device code set
up” and resets the Volume Lock to “TV.”
To reset the features:

While holding down the RECALL button, press 9 –8 –0.
The Mode indicator will blink two times, and then pause and
blink two more times.

Number

MODE

RECALL

VOL

y z