Raid setup and firmware installation, Click config, Setting up the raid – Thecus Technology M3800 User Manual

Page 17: Select a stripe size – the default is 64k

Text mode
Original mode

RAID Setup and Firmware Installation

Once the setup wizard has completed, you should now be inside the Web Admin
Interface. From here, it is time to initialize your RAID system and install the

firmware for the M3800.

The next steps are for first time setup only. If you have previously setup your

M3800, you can skip this section of the setup process.

NOTE

Setting up the RAID

1. From the Web Admin Interface, navigate to Storage > RAID. The RAID

Information screen appears.

Click

Config.

2. Select your desired RAID level, and check the checkboxes of the disks you

wish to use in your array.

3. Select a stripe size – the default is 64K.

4. Click Create to create your selected RAID volume.