Trango Broadband M900S - Manual (Page 48)

Trango Broadband Wireless — User Manual M900S Rev. C Page 44
Command Radio Description Access
(power leveling)
pppoeonly SU Display current PPPoE filter setting ro/rw
pppoeonly SU Change PPPoE filter setting
With PPPoE filter set to ON, only PPPoE packets will pass Default:
off – Pass All Packets rw
reboot AP/SU Reboot unit ro/rw
remarks AP/SU Display remarks ro/rw
remarks AP/SU Overwrite remarks rw
reset AP/SU Reset radio’s system settings back to factory defaults, then reboot rw
rfrxth AP/SU Display current RF RX Threshold ro/rw
rfrxth <-98..-55> AP/SU Change current RF RX Threshold
default = -98 dBm rw
rssi AP/SU Display current RX RSSI
Opmode “OFF” only on AP ro/rw
save chscksum> AP/SU Save new firmware. This command gets new firmware image from
TFTP buffer, verifies checksum and writes to flash memory at main
or FPGA image section.
rw
save sudb AP Save SUDB into flash memory rw
save AP/SU Save current configuration into flash memory rw
set apid AP Set AP ID, = 1..255 rw
set baseid AP/SU Set base station id Base ID = XXXX where X = any alphanumeric
character except “/” rw
set defaultopmode AP/SU Set default Opmode to “ON” or “OFF”
Factory set default Opmode is “OFF” rw
set httpport [] AP/SU Set or display HTTPD port number
port # = 1..65534
default port = 80 rw
set snmpcomm AP/SU Set SNMP read or write or trap community string rw
set telnetport [] AP/SU Specify telnet port, = 1..65534
Default port = 23 rw
snmpsample AP/SU Set SNMP sample period rw
su password password> AP Change read/write or read-only password of all or a specific
subscriber rw
su AP Display all or specific SU information in SUBD ro/rw
su info AP Command issued from the AP to gather information about specific
SUs.
1. Distance
2. RSSI at AP
3. RSSI at SU
4. IP
address
5. Subnet address
6. Gateway address
7. Device ID
8. Hardware version
9. FPGA version
10. FPGA checksum
11. Firmware version
12. Firmware checksum
13. Firmware datecode
14. Broadcast/multicast packet filter on/off
15. Auto scan AP on/off
16. TCP/IP for AP on/off
17. HTTPD on/off
18. TCP/IP service for Ethernet port on/off
19. Default channel and antenna
20. Active channel and antenna
ro/rw