Toshiba TEC SL-9000-ESB-X SERIES - Manual (Page 41)

11-16
11. PROGRAMMING PROCEDURES
11.3 INGREDIENT MESSAGE
11.9 INGREDIENT MESSAGE
Menu Group: 1
Item No.:
11
Ingredient messages can be printed on a label with a maximum of 54 characters per line in small letters
or 32 characters per line in boldfaced small letters, by up to 38 lines.
C
The memory file
is sorted when a
memory full error
occurs.
TEST
PROG.
ESC.
Sorting
Not Sorting
Any key
except Y
Group 1
Main
11 ENTER
or
NEXT
PLU
Enter the PLU#
(max. 6 dig.)
Enter the ingredient message
(Refer to Page 11-3.)
Pressing the key
calls data stored by pressing
the key.
Pressing the key
temporarily stores data into
the work buffer.
RECEIVE
SEND
SEND
ENTER
Y
C
NOTES:
1. When no data is programmed for the PLU, ingredient cannot be set.
2. When a selected PLU is not stored in the PLU file, a “PLU NOT FOUND” error occurs.
3. Once you exit this menu and enter again, data stored in the work buffer is cleared.
4. When there is no area to store ingredient data, a “MEMORY FULL” error occurs.
5. PLUs cannot share ingredient data. (PLU and ingredient data are in pairs.)
PROG.