Toshiba CS4000B Series - Manual (Page 14)

6
D4134844A
② CLOCK
･Output level
2.0±0.3V(p-p)(on no-load condition)
･Frequency
(EIA) 14.31818MHz±100ppm(on no-load condition)
(CCIR ) 14.18750MHz±100ppm(on no-load condition)
③ WEN On operate random shutter mode, WEN put out from
the fall time of VD to the fall time of VD under put
out video signal..
･Polarity Positive
･Diagram The circuit is shown in the figure below
(21) Electronic shutter Shutter speed can set by front panel switch As follow:
OFF,1/125,1/250,1/500,1/1000,1/2000,
1/4000,1/10000, F.L
1FLD,2FLD,4FLD,6FLD,8FLD,10FLD
(slow speed shutter mode)
(22) Random shutter RTS mode selection available
Mode1 Shutter-speed switch setting Internal sync SYNC non-reset
Mode2 Shutter-speed switch setting Internal sync SYNC non-reset
Mode3 Shutter-speed switch setting Internal sync SYNC Reset
Mode4 Shutter-speed switch setting Internal sync SYNC Reset
Mode5 Shutter-speed switch setting SeriesＨＤ，SeriesＶＤinput SYNC non-reset
Mode6 Shutter-speed switch setting SeriesＨＤ，SeriesＶＤinput SYNC non-reset
Mode7
Shutter-speed switch setting
SeriesＨＤ，One-pulseＶＤinput SYNC non-reset
Mode8
Shutter-speed switch setting SeriesＨＤ，One-pulseＶＤinput
SYNC non-reset
(23) Special shutter
User-defined shutter-speed cued and timed by shutter
trigger and restart / reset pulse input ON /OFF
selectable via rear panel DIP SW.
(Initial factory setting :OFF)
(24) Restart Reset Restart Reset function available via rear DIP SW selection.
(25) Lens Mount Special Mount, by each head specification.
(26) Mass Camera control unit: about 350g
(27) GND Circuit GND---Chassis: Electrically continuous
(28) EMI Conforms to EN50081-2
WEN
2SC4176
51
10k
4700