Toshiba NVR16-X - Manual (Page 9)

ix
Notes on Handling
„ When shipping the NVR unit, the original shipping carton
packing materials come in handy. For maximum protection,
repack the unit as it was originally packed at the factory.
„ Do not use volatile liquids, such as insect spray, near the NVR
unit. Do not leave rubber or plastic products in contact with the
NVR unit for long periods of time. They will leave marks on the
finish.
„ The top and rear panels of the NVR unit may become warm
after long periods of use. This is not a malfunction.
Notes on Locating
„ Place the NVR unit on a level surface. Do not use it on a shaky
or unstable surface such as a wobbling table or inclined stand.
„ When you place this NVR unit next to a TV, radio, or VCR, the
playback picture may become poor and the sound may be
distorted. In this case, place the NVR unit away from the TV,
radio, or VCR.
Notes on Cleaning
Use a soft dry cloth for cleaning.
„ For stubborn dirt, soak the cloth in a weak detergent solution,
wring well and wipe. Use a dry cloth to wipe it dry.
Do not use any type of solvent, such as thinner and benzene,
as they may damage the surface of the NVR unit.
„ If you use a chemical saturated cloth to clean the unit, follow
that product’s instructions.
Notes on Maintenance
This NVR unit is designed to last for long periods of time. To keep
your NVR unit always operational we recommend regular inspection
maintenance (cleaning parts or replacement). For details contact
your nearest dealer.
Notes on Moisture Condensation
Moisture condensation damages the NVR unit. Please read the
following carefully.
Moisture condensation occurs during the following cases.
„ When you bring the NVR unit directly from a cold place to a
warm place.
„ When you use the NVR unit in a room where you just turned on
the heater, or a place where the cold wind from the air
conditioner directly hits the unit.
„ In the summer, when you use the NVR unit in a hot and humid
place just after you move the unit from an air conditioned room.
„ When you use the NVR unit in a humid place.
Do not use the NVR unit when moisture condensation may
occur.
If you use the NVR unit in such a situation, it may damage discs and
internal parts. Remove any CD discs, connect the power cord of the
NVR unit to the wall outlet, turn on the NVR unit, and leave it for two
to three hours. After two to three hours, the NVR unit will have
warmed up and evaporated any moisture. Keep the NVR unit
connected to the wall and moisture will seldom occur.