Toshiba 20HL85 - Manual (Page 23)

23
Introduction
Connecting your TV
Setting up your TV
Using the TV
’s Features
Appendix
CT-885
INPUT DISPLAY
Adding channels to the TV’s memory
When you press CH
3 or 4, your TV will stop only on the channels you
have stored in the TV’s channel memory. Follow the steps below to
program channels into the channel memory.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channels automatically:
1. Press TV to select the TV mode.
2. Press MENU, then press or to display the SETUP menu.
3. Press
▲ or ▼ until the TV/CABLE
selection is highlighted.
4. Press or to highlight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
5. Press ▼ until the CH PROGRAM selection is highlighted.
6. Press to start channel programming. The TV will automatically
cycle through all the TV or Cable channels (depending on which you
selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
“PROGRAMMING NOW-PLEASE WAIT” appears.
7. When channel programming is complete, the message “COMPLETED”
appears.
8. Press CH
3 or 4 to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels manually:
1. Press TV to select the TV mode.
2. Select the channel you want to add or erase. If adding channels, you
must select the channel to add using the Channel Number buttons.
3. Press MENU, then press or to
display the SETUP menu.
4. Press ▲ or ▼ to highlight ADD/
ERASE.
5. Press or to select ADD or
ERASE, whichever function you
want to perform.
6. Repeat steps 1-5 for other channels you want to add or erase.
Changing channels
To change to the next programmed channel:
Press Channel
3 / 4 on the TV or CH 3 / 4 on the remote control.
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0-9 and 100) on the remote control.
For example, to select channel 125, press 100, 2, 5.
S E T U P
L A N G U A G E
C L O C K S E T
T V / C A B L E
C H P R O G R A M
A D D / E R A S E E N G L I S H
1 2 : 0 0 A M
T V /
C A B L E
A D D
: S E L E C T : A D J U S T
In addition to cycling through your
programmed channels, the Channel
3 / 4
buttons will also cycle through the video
input sources (page 30) in the order
illustrated below.
PC
ANT (programmed channel) VIDEO1 VIDEO2
HDMI ColorStream HD
Menu
Channel
3 4
Channel
Numbers
Setting up your TV
S E T U P
L A N G UAG E
C L O C K S E T
T V / C A B L E
C H P R O G R A M
A D D / E R A S E E N G L I S H
1 2 : 0 0 A M
C A B L E
A D D / E R A S E
: S E L E C T : A D J U S T
Note:
If the remote control does not operate your TV,
press the “TV” button on the remote control
and try again.
TV
J3U70101C(E)P17-24 15/06/2005, 4:11 PM 23