Telenetics DSP9612RM - Manual (Page 13)

Configuring the Modem
Page 13
Table 2-1. Modem Switch Settings for High-Speed Mode
Switch Settings Switches
ON OFF (Default)
SW 1-1
− 1-4: Transmit Level (page 14)
(see Table 2-2 on page 14)
SW 1-5: Receiver Dynamic Range
(page 15)
−10 to −43 dBm
+3 to
−30 dBm
SW 1-6: TX Cable Equalizer (page 15) Enabled Disabled
SW 1-7: RX Cable Equalizer (page 15) Enabled Disabled
SW 1-8: Anti-streaming (page 15) Active Inactive
SW 2-1: High-Speed/Low-Speed Mode
(page 16) Low-Speed Mode
(FSK) High-Speed Mode
(Fast Poll)
SW 2-2: Data Rate in Fast Poll Mode 4800 bps 9600 bps
SW 2-3: Async Character 11 bits 10 bits
SW 2-4: Auto RTS (page 16) Enabled Disabled
SW2-5: Reserved
SW 2-6: Production Test Only (page 16) Test Normal
SW 2-7: 2- or 4-wire (page 16) 2-wire, half-
duplex 4-wire, full-duplex
SW 2-8: Carrier Control (page 17) Constant Switched
SW 2-9: Rx Termination (page17) Disabled Enabled
SW 2-10: Ground Options (page 17) Chassis Ground-
Signal Ground
Connected Chassis Ground-
Signal Ground
Disconnected