Texas Instruments DEM-DAI3010 - Manual (Page 11)

Setting Functions
1-5 Description
- Data and a clock are supplied to the PCM3010 side of JP107.
- Set up FMT0 and FMT1 of SW101 according to the data format to be used.
- Set up DEMP0 and DEMP1 of SW101 for the desired de-emphasis of the
DAC section and PWDN for the power-down setting.
1.4 Setting Functions
All functions of the devices (PCM3010, DIR1703, DIT4096) on the
DEM-DAI3010 are controlled by DIP switches or header pins on this PCB.
Therefore, the DEM-DAI3010 does not require a microcontroller or software
to transmit data to internal function-setting registers. For specific information
on any device, see the data sheet for that device.
1.4.1 Function Setting Switches and Header Pins
Table 1–3. Switches and Header Pins of the DEM-DAI3010
SW/JP No. Item Shape
SW001 S/PDIF input selection (optical/coax) Toggle switch
SW002 Reset of DIR1703 and DIT4096 Pushbutton switch
SW003 Format and system clock setting of DIR1703 4-pole DIP switch
SW004 Output clock selection of DIR1703 (X’tal/Auto/PLL) Toggle switch
SW005 Format and system clock setting of DIT4096 4-pole DIP switch
SW006 Channel status data setting of DIT4096 10-pole DIP switch
SW051 S/PDIF output selection (optical/coax) Toggle switch
SW101 Setting of PCM3010 (format, de-emphasis, power down) 5-pole DIP switch
JP001 Crystal frequency and system clock setting of DIR1703 2
×
5 header
JP107 Connection of S/PDIF I/O circuit and PCM3010 2
×
7 header
JP101 Cutoff frequency setting of DAC output filter (L-ch) 2
×
2 header
JP102 Cutoff frequency setting of DAC output filter (R-ch) 2
×
2 header
JP103 Cutoff frequency setting of DAC output filter (L-ch) 2
×
1 header
JP104 Cutoff frequency setting of DAC output filter (R-ch) 2
×
1 header
JP105 Selection of L-ch ADC input terminal (CN101/CN103) 2
×
2 header
JP106 Selection of R-ch ADC input terminal (CN102/CN104) 2
×
2 header
CN057 The way of power supply of PCM3010 V
DD
(3.3 V) 2
×
1 header
Note: The relation between the DIP switch setting (ON/OFF) and the setting of the IC input port is printed on the PCB. The DIP
switch H position does not always set the IC input port level HIGH.
Toggle switch settings are printed on the PCB.