Yamaha DVD-S540 - Manual (Page 20)

16
DIGITAL AUDIO SETUP
In this menu, you can set up the digital audio
output signal from the digital jacks, such as coaxial
etc.
DIGITAL OUTPUT
1 Press 34 to highlight DIGITAL OUTPUT.
2 Enter its submenu by pressing 2.
3 Press 34 to highlight the selected item.
➜ ALL: Original digital signals output. In this
mode, all audio settings except MUTE are invalid.
➜ PCM Only: If your receiver is PCM-
compatible, or your receiver can not decode
MPEG-2, Dolby Digital, or DTS audio, choose this
option.
4 Press ENTER/OK.
5 Press 1 and return to the Audio Setup Page.
Note: If DIGITAL OUTPUT is set to “ALL”, all audio
settings except MUTE are invalid.
LPCM OUTPUT
In this menu, you can select PCM digital output
between 48kHz and 96kHz.
1 Press 34 to highlight the “LPCM OUTPUT”.
2 Enter its submenu by pressing 2.
3 Move the cursor by pressing 34 to highlight the
selected item.
➜ 48K: 96kHz (if available on disc) PCM data
stream will be converted to 48kHz.
➜ 96K: If the 96kHz disc is copy protected, the
digital output will be muted to comply with the
standards.
4 Press ENTER/OK.
5 Press 1 to return to the Audio Setup Page.
EQUALIZER (Sound Mode)
The “EQUALIZER” allows you to select from
various preset modes that control the frequency
bands of sound to optimize certain musical styles.
It greatly enhances the excitement and enjoyment
of your favourite music.
1 Press 34 to highlight the “EQUALIZER”.
2 Enter its submenu “SOUND MODE” by pressing
2 .
3 Press 2.
4 Move the cursor by pressing 34 to highlight the
selected item.
➜ NONE: Play the disc under the original sound
effect.
5 Press ENTER/OK.
6 Press 1 to return to the Audio Setup Page.
Note: The sound may be distorted if the selected
sound mode is incompatible with the disc contents.
In that case, select another sound mode or
“NONE”.
3D (REVERB MODE)
The “3D” can simulate the echoes and frequency
response of some particular places so as to make
you feel like personally on the place.
1 Press 34 to highlight the “3D”.
2 Enter its submenu “REVERB MODE” by pressing
2 .
3 Press 2.
4 Move the cursor by pressing 34 to highlight the
selected item.
➜ OFF: Play the disc under the original sound
effect.
5 Press ENTER/OK.
6 Press 1 to return to the Audio Setup Page.
Setup Menu