8trouble shooting – Topcom BUTLER 4200 User Manual
Page 24

24
Topcom Butler 4200/Twin/Triple/Quattro
Topcom Butler 4200/Twin/Triple/Quattro
7.3
Setting up a handset on another base
If you want to use a Butler 4200 handset with a base of another model. The base must be
GAP compatible.
1.
To get the base into registration mode, refer to the user manual of the base.
2.
Carry out steps 3 to 9 of paragraph 7.1 “Setting up an additional handset”.
8
Trouble shooting
Symptom
Possible cause
Solution
No display
Batteries uncharged
Check the position of the
batteries
Recharge the batteries
No tone
Telephone cord badly
connected
Check the telephone cord
connection
The line is occupied by another
handset
Wait until the other handset
hangs up
The icon
flashes
Handset out of range
Bring the handset closer to the
base
The base has no power supply
Check the mains connection to
the base
Base or handset do not
ring
The ringing volume is zero or
low
Adjust the ringing volume
Tone is good, but there
is no communication
The dialling mode is wrong
Adjust the dialling mode
(pulse/tone)
Not possible to transfer
a call on PABX
The FLASH time is too short
Set the unit to longer flash time
Telephone does not
react when pressing the
keys
Manipulation error
Remove the batteries and put
them back in place
DECT GAP Profile only guarentees that basic calling-functions will work
correctly between different brands/types. There’s a possibility that certain
services (like CLIP) will not work correctly.