Tascam MMP-16 - Manual (Page 9)

TASCAM MMR-8/MMP-16 Version 4.0 Owner’s Manual Update 8
Undo / Redo Change
100 levels of Undo and Redo are now supported on all MM series units. Previous to Version 4.0,
there were only 10 levels of Undo and Redo.
Clip Names
Clip Names for new audio recordings are now set when in non-destructive record mode. The
name format for MMR-8 clips will show the track prefix, followed by a track take number that
increments for each new track created, but will be the same for all clips created on a track,
followed finally by a sequential clip number that increments each time a new clip is recorded.
The MM series unit only shows track names, but clip names are stored and can be shown if the
file is taken to a digital audio workstation (WaveFrame or Pro Tools) or displayed on the
ViewNet Audio project view screen.
In & Out Points Set In Record
The In and Out time registers are now automatically set to correspond to the beginning and end
of a record punch operating when in non-destructive record mode.
Menu 620 Eliminated
Setup menu item 620, labeled Rate Conversion has been eliminated. This was an essentially
unused feature which allowed a choice of Slow Response or Fast Response when using sample
rate conversion. Setting of this parameter was deemed to be unnecessary for the successful use of
the Rate Conversion function. The Rate Conversion feature still functions, but there are no user
parameters associated with the function.
Track
Prefix
Trk
#
Track
Take # Clip #
Dlog Trk3_01112_135
Track Name