Teac W-860R - Manual (Page 11)

ENGLISH
11
Parallel Recording
A single program source can be recorded onto the two cassette
tapes simultaneously.
1. Follow the steps 1 to 6 described in "Recording with
TAPE I and TAPE Il" except that in step 3, load cassette
tapes into both TAPE I and TAPE Il. (See page 10)
2. Press the PARALLEL REC button.
Notes:
… Recording will start in the direction indicated by the direction
indicator; therefore, set the direction beforehand.
… During recording, only following buttons are operational:
TAPE I : STOP button
TAPE Il : STOP, REC MUTE and PAUSE buttons
… To stop recording, press the STOP button. Both TAPE I and
TAPE Il will stop.
MIC/LINE Mixing Recording (TAPE I and TAPE Il)
Using this unit, you can mix and record the MIC inputs and
LINE IN inputs.
1. Plug microphones equipped with a standard phone plug
into the MIC jack on the front panel of this unit.
2. Use headphones to monitor the inputs.
This prevents acoustic feedback, 'howling', that might occur
if you listen to the sound from the speakers.
3. Press the RECORD button.
The deck enters the record-pause mode.
4. Balance the relative levels of MIC inputs and LINE IN
inputs with MIC LEVEL and REC LEVEL knobs.
Be sure to keep the total input level within the limitations
indicated by the peak level meters.
5. Press the PAUSE button to start recording.
Continuous Recording (TAPE I to TAPE Il)
1. Load two recordable cassette tapes into TAPE I and ll.
2. Set the NR SYSTEM and REC LEVEL as required.
3. Set the REV MODE switch to the
ä
position.
4. Press the RECORD button, then
PAUSE (or play) button of TAPE I to
start recording.
After recording with TAPE I is
completed, TAPE ll starts recording
automatically in the forward direction.
5. To clear the continuous recording mode, press the STOP
button.
Notes:
… In continuous recording, since recording with TAPE II always
begins in the forward direction, make sure the cassette tape
loaded in TAPE Il can be recorded on both sides.
… If the tape running direction is set to reverse side of TAPE l,
recording will be done on only the reverse side of the tape
loaded in TAPE l.
… Continuous recording from TAPE II to TAPE I is impossible.
MIC
LINE
W-860R
MIC/LINE Mixing Recording
п
Л
д