Toshiba B-852-TS12-QQ - Manual (Page 74)

APPENDIX 1 SPECIFICATIONS EO1-33029
A1.3 Media
A1- 4
A1.3.3 Detection Area of the Reflective Sensor
The reflective sensor is movable from the center to the left edge of media.
The reflection factor of the black mark must be 10% or lower with a waveform length of 950 nm.
The reflective sensor should be aligned with the center of the black mark.
A1.3.4 Effective Print Area
The figure below illustrates the relation between the head effective print width and media width.
The figure below shows the effective print area on the media.
Sensor should be positioned at
the center of the black mark.
Center of media
Min. 10 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
12.6mm
242 mm (Max. media width)
216.8 mm ± 0.2
(Head Effective Print Range)
Out of print range
Out of print range
12.6mm
NOTES:
1. Be sure not to print on the 1-mm wide area from the media edges (shaded area in the above figure).
2. The center of media is positioned at the center of the print heads.
Detecting the black
marks on the back.
Start line
Area to be detected.
Area to be detected.
Media feed direction
1 mm from the
left edge of
media
Media width
(backing paper width is not included.)
Media height
10 – 640 mm
1 mm from the right
edge of media
1mm
1mm
Guaranteed print area