Texas Instruments 3000 MCU - Manual (Page 24)

SpectraLink Corporation T1 Remote Module Installation
Link WTS – Link 3000 MCU
6. Site Certification
The installer should not leave the site before contacting SpectraLink to perform
remote install verification.
Before leaving the location where the Primary Shelf is installed, the installer must
complete the following items:
From the Operator’s Console, copy the PCS.CFG file to diskette. From the
Operator’s Console, select F1 (Supervisor State) then select Dump Config to
PCS.CFG. See the Operator’s Console document for more information.
Give the system administrator a map of the system showing the final Base Station
locations at local and remote sites.
Perform end user and administrative training.
Get a signature on the acceptance document. This document confirms that the
installation has been correctly carried out, that the coverage area is correct, and that
the client’s personnel have been trained.
The installation is not complete until all certification steps have been performed.
Wireless Telephones should not be handed out until the site has been certified.
Part Number: 72-0059-06-E.doc Page 24