beautypg.com

Triax dvb 75 si – Triax DVB 75SI User Manual

Page 17

background image

TRIAX DVB 75 SI

17

You can use the [P+] and [P-] buttons of the remote control to go to
the previous or next channel of the programme list.

You can use the numeric buttons of the remote control [0-9] to select
any channel number from the active programme list. The numbers
entered are displayed in a small box at the bottom left-hand corner of
your TV screen.

If you hesitate more than 3 seconds after entering a
number of the channel number, the satellite receiver
assumes that you have completed your entries and
switches to the channel number entered.

The satellite receiver will switch more rapidly if you
press the [OK] button when you have entered the last
number.

The [arrow up] and [arrow down] buttons of the
remote control can be used for changing channels
just as [P+] and [P-]. Note that these two buttons
may have another function during execution of an
OpenTV application, which may take over both
buttons.

4XLFNFKDQJHRIFKDQQHOVIURPWKHIURQWSDQHO

In addition to the [standby] button on the satellite receiver front
panel, there are two buttons that have the same functions as the
[P+] and [P-] buttons of the remote control, as described above.

4XLFNFKDQJHRIFKDQQHOVYLDDVFUHHQOLVW

As an alternative to the methods for change of channel described
above a screen picture can display the active programme list.

The programme list will be displayed on the screen
when the [OK] button is pressed during ordinary TV
watching.

You can scroll through this programme list using the
[arrow buttons] of the remote control and switch to
any channel by marking it in the list and pressing the
[OK] button of the remote control.

At the top of the screen you can see which
programme list is currently active (the picture shows
a red list, the Danish programme list). You may
change to one of the other lists by setting the receiver
in standby mode (press the [standby] button), and
switching it on again by pressing one of the other
[coloured buttons].

When the [back] button is pressed, the screen list
will disappear without any change of channel.

$%

(;7

799&56$7

#

3

3