Technicolor - Thomson DTH 2000 - Manual (Page 37)

Angle / rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Languages
. . . . . . . . . . . . . . . . . . . . . . .
19 / 22-23
Audio CD / video CD specials . . . . . 20-21
Basic set-up
. . . . . . . . . . . . . . . . . . . . .
4-5, 22-25
Universal remote control . . . . . . . . . . . 30-33
What to do if... / Index
. . . . . . . . . . . . . .
42-45
Audio connections
37
set-up
When connecting the optical
audio digital cable: 1. Remove the dust protection cap
from the connector and connect
it firmly as shown on the
drawing.
2. Keep the dust protection cap and
always reattach the cap when
not using the connector, to
protect against dust.
• Linear PCM is a signal recording
format used in CDs. While CDs
are recorded in 44.1 kHz /
16 bit, DVDs are recorded in
48 kHz / 16 bit up to 96 kHz /
24 bit.
* The type of audio output from
the connector you can select
during the set-up procedure
(see page 25).
** The player converts sound
having 96 kHz sampling, into
48 kHz sampling before it is
output from the unit's optical /
coaxial digital audio output
connector.
This player's digital audio (optical and coaxial)
output jacks:
fully comply with the international standard governing this type of
jack (IEC 958). They are designed exclusively for connection to a
Dolby Digital (AC-3) or MPEG2 audio receiver or a suitable
decoder.
Do not use ...
the Digital Audio Output jacks to connect to an equipment other
than a Dolby Digital (AC-3) or MPEG 2 receiver or a suitable
decoder.
Such a connection can create a high level of noise that may be
harmful to your ears, and could damage headphones or speakers.
Older digital equipment, some of which is not fully compliant
with IEC 958, is likely to cause this problem.
The same should be applied with the so-called "optical or coaxial
REC.OUT jack" of Dolby Digital (AC-3) decoders, when they are
connected to this DVD player. Since REC.OUT is a 1:1 copy of
the decoder's input, no other equipment should be connected
there.
The audio output from the unit's optical / coaxial
digital audio output connector
Sound recording on the Digital audio output from
disc optical / coaxial connector
DVD Dolby Digital Dolby Digital bitstream
(AC-3) (2 – 5.1 channels) or
linear PCM (2 channels,
48 kHz / 16 bit) *
Linear PCM (48 / 96 kHz Linear PCM (2 channels,
16 / 20 / 24 bit 48 kHz sampling / 16 bit
only), or no output **
MPEG2 MPEG audio bitstream or
linear PCM (2 channels,
16 bit) *
Video CD MPEG1 Linear PCM
(44.1 kHz sampling)
CD Linear PCM Linear PCM
(44.1 kHz sampling)