True Manufacturing Company GDM-3 - Manual (Page 8)

7 7
A. The compressor is ready to operate. Plug in the cooler.
B. The refrigerator is designed to maintain cabinet
temperatures of 38˚F to 40˚F (3.3˚C to 4.4˚C).
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your
TRUE dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful
to load product so that it neither presses against the back
wall, nor comes within two inches of the evaporator
housing. Refrigerated air off the coil must circulate down
the back wall.
NOTE
If the cooler is disconnected or shut off, wait five minutes before
starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE unit
empty for two to three days. This allows you to be sure electrical
wiring and installation are correct and no shipping damage
has occurred. Remember, our factory warranty does not cover
product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your
cooler. If at any time during the life of your cooler, a part is
needed, you may obtain this part by furnishing the model number
and serial number to the company from whom you purchased
the cooler. Call Toll-Free: (800)-424-TRUE (Direct to Parts
Department). (800)-325-6152 (U.S.A. & Canada only) or call:
(636)-240-2400.
STARTUP
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
True Food Service Equipment, Inc.
SHELVING INSTALLATION /
OPERATION
SHELF INSTALLATION:
Step 1
A. Hook shelf clips onto shelf standards.
(see illustration).
B. Position all four shelf clips equal in distance from the
floor for flat shelves.
WIRE SHELVES:
Wire shelves are oriented so that cross support bars are
facing down.
Step 2
Place shelves on shelf clips making sure all corners are
seated properly.
Shelf
Clip
Shelf
Temperature Control and light switch are located next to each other on
the interior ceiling of the cabinet behind the light and cabinet fan.
The evaporator drain pan is located inside the refrigerator and it
needs to be manually drained
1
2