beautypg.com

Electrical instructions, Sealing cabinet to countertop – True Manufacturing Company GDM-3 User Manual

Page 7

background image

6

6

............ www.truemfg.com ............

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

A. Before your new unit is connected to a power supply,

check the incoming voltage with a voltmeter. If

anything less than 100% of the rated voltage for

operation is noted, correct immediately.

TRUE requires that a sole use circuit be dedicated for the

unit. Failure to do so voids warranty.
WARNING

Compressor warranties are void if compressor burns out

due to low voltage.
WARNING

Power supply cord ground should not be removed!

ELECTRICAL INSTRUCTIONS

Step 1 - Position Cabinet
Allow one inch between the wall and rear of the GDM

refrigerator to assure proper ventilation. For GDM

freezers 3 inches between the wall and rear of the cabinet

will assure proper ventilation.
Step 2 - Level Cabinet
Cabinet should be level, side to side and front to back.

Place a carpenter’s level in the interior floor in four

places:
A. Position level in the inside floor of the unit near the

doors. (Level should be parallel to cabinet front).

Level cabinet.

B. Position level at the inside rear of cabinet. (Again level

should be placed parallel to cabinet back).

C. Perform similar procedures to steps a & b by placing

the level on inside floor (left and right sides - parallel

to the depth of the cooler). Level cabinet.

Step 3
Draw an outline on the base on the mounting surface.
Step 4
Raise and block the front side of the cabinet.
Step 5
Apply a bead of “NSF Approved Sealant”, (see list

below), To the surface one half inch inside the outline

drawn. The bead must be heavy enough to seal the entire

cabinet surface when it is down on the sealant.

Step 6
Raise and block the rear of the cabinet
Step 7
Apply sealant to the surface as outline in Step 5. on other

three sides.
Step 8
Examine to see that cabinet is sealed to countertop

around entire perimeter.

NSF Approved Sealants:
1. Minnesota Mining #ECU800 Caulk
2. Minnesota Mining #ECU2185 Caulk
3. Minnesota Mining #ECU1055 Bead
4. Minnesota Mining #ECU1202 Bead
5. Armstrong Cork - Rubber Caulk
6. Products Research Co. #5000 Rubber Caulk
7. G.E. Silicone Sealer
8. Dow Corning Silicone Sealer

SEALING CABINET TO COUNTERTOP