Toshiba D-R160SB - Manual (Page 19)

Introduction
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
19 EN
Installing batteries in the remote
control About the remote control
Preparation of the remote control
■ Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the
polarity indicated inside the battery
compartment.
1
Open the cover.
2
Insert batteries.
Make sure to match the + and - on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
■ Keep in mind the following when using the
remote control:
● Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
● Use within the operating range and angle as
shown.
● Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
● Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
● Replace the batteries when the operating range of
the remote control reduces.
● The maximum operable range as follows:
- Line of sight:
approximately 7 m
- Either side of the centre:
approximately 7 m within 30 degrees
REC MODE REC
PROGRAM
ON/STANDBY
I /y
Notes:
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the + and - ends of each battery match the
indications inside the battery compartment.
• Remove batteries if the remote control will not be used for
an extended period of time.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or
area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.