Timex M805 User Manual

Page 4

6. When workout is completed, press and hold STOP/RESET/SET to reset

Chrono.

TIP: When Chrono is running,

appears in Time display.

CUSTOMIZE DISPLAY FORMAT:
This determines what is shown in first and second lines of the display.
1. When Chrono is reset, press and release STOP/RESET/SET.
2. Press + / – to select LAP/SPL (Split in large digits), SPL/LAP (Lap in

large digits), or TOTAL RUN.

3. Press STOP/RESET/SET to exit.

NOTE: TOTAL RUN format allows you to view total elapsed time and

total activity time (total activity time=total elapsed time - time paused

during workout).

USING THE TOTAL RUN FEATURE IN CHRONO:
Select TOTAL RUN display format as described above.

1. Press START/SPLIT to start Chrono.
2. Press STOP/RESET/SET every time you pause/stop during your work-

out. Primary display will show time elapsed less paused time (total

activity time). Upper display will continue to run, showing total

elapsed time since Chrono was started.

TIPS:
• When you have completed a workout in this format, total elapsed

time will continue to run until Chrono is reset.

• When recalling TOTAL RUN, only total activity time will be displayed.
• Elapsed time counter will continue to run until Chrono is reset. If you

take a split, display will change to LAP/SPL Elapsed time is not stored

in memory.

RECALL

1. Press MODE until RECALL appears.
2. Press + / – to review Lap/Split times of successive laps, BEST lap,

AVG lap.

TIPS:
• Press STOP/RESET/SET at any time to return to viewing first Lap/Split

time.

9. Press DONE to exit.
TIPS:
• Press and hold START/SPLIT briefly to peek at next Time Zone. Press

again quickly to view 3rd time zone.

• Press and hold START/SPLIT while next Time Zone is displayed to

change to that Time Zone. Watch will beep to confirm change.

CHRONO

Chrono counts up to 99 laps (100 hours max.) and stores 50 laps.

IPOD FUNCTION IN CHRONO MODE:
p and U iPod functions share the buttons with important Chrono

functions (START/SPLIT and STOP/RESET/SET, respectively):

All other iPod functions operate normally.

USING THE CHRONO:
1. Press MODE until CHRONO appears.
2. Press and release START/SPLIT to start Chrono. Chrono continues to

run if you exit the mode.

3. Press and release START/SPLIT to take a split. Lap number alternates

with last two digits of display.

4. Display will freeze for 10 seconds. Press MODE to release display and

see running Chrono.

5. Press and release STOP/RESET/SET to stop or pause Chrono. Press

and release START/SPLIT to resume.

Chrono is:

START/SPLIT Button

STOP/RESET/SET Button

Reset
(00:00.00)

Press and release - START
Press and hold -

Press and release -
Change Display Format
Press and hold -

Running

Press and release - SPLIT
Press and hold -

Press and release - STOP
Press and hold -

Stopped

Press and release - START
Press and hold -

Press and release -

Press and hold - RESET

T0705-13_W240_EN_NA.qxd 5/17/07 2:05 PM Page 4