Timex M805 User Manual

Page 3

3. Press

p button, ensure iPod responds to the command correctly. If

not, remove receiver from iPod and repeat steps 2 and 3 until iPod

responds correctly.

You are now ready to wirelessly control your iPod with your watch!
TIPS:

•

will be visible on display in modes where iPod use is possible

(TIME, CHRONO, INTERVAL TIMER and TIMER modes).

• There will be a slight delay in the iPod's response to button presses

on the watch. This is normal.

• Fast-forward or reverse through the currently playing track is not

available, therefore holding

U or u watch buttons has no effect.

• It is not possible to turn your iPod off by holding

p button.

• The i-Control® watch is designed to operate up to a range of about

10 ft. (3 m). Range will be affected by watch and iPod battery voltage.

If range is greatly reduced even with iPod fully charged, it may be

necessary to replace watch battery. Refer to battery change instruc-

tions at the end of these instructions.

• Receiver is powered by iPod, therefore use of the i-Control system

will reduce time between charges for the iPod. Unplug receiver from

iPod when not using the i-Control system.

TIME/DATE/HOURLY CHIME

SETTING TIME AND DATE:
1. In TIME mode, press and hold STOP/RESET/SET. Time Zone flashes.
2. Press + or – to select Time Zone 1, 2 or 3.
3. Press NEXT to set hour. Digits flash.
4. Press + or – to change hour. Scroll through 12 hours to change to

AM/PM.

5. Press NEXT and + / – to set minutes.
6. Press NEXT and + / – to set seconds to zero.
7. Continue pattern to set day, month, date, year, 12-hour (AM/PM) or

24-hour military time format, MM.DD or DD.MM date format, turn

hourly Chime on/off, turn Beep on/off. If you select Beep on, beep will

sound every time you push a button except INDIGLO® button.

8. Press NEXT to set next Time Zone, following procedure above.

BASIC OPERATIONS

When setting, each button has a different function as indicated above.

Display indicates when button changes function.

IPOD CONTROL

GETTING STARTED WITH YOUR i-CONTROL® WATCH
Perform these steps each time you are attaching the receiver device to

your iPod to ensure reliable operation:
1. Press MODE until watch is in TIME mode.

will be visible on display.

2. Plug receiver into iPod dock connector.

START/SPLIT

INDIGLO

BUTTON

STOP/RESET/SET

OR DONE (To save

changes and exit

setting)

MODE OR NEXT

(Proceed to next step)

VOLUME UP

OR Increase value.

Hold to increase rapidly

NEXT TRACK

OR Proceed to next step

VOLUME DOWN

OR Decrease value.

Hold to decrease rapidly

iPod® ICON

PREVIOUS TRACK

(Refer to Mode

descriptions for

operation)

PLAY/PAUSE