Tektronix MTM400 User Manual

Page 61

Device View

MTM400 MPEG Transport Stream Monitor User Manual

3-13

Identify the firmware Filename

(either by entering the path and filename or

using Browse.

Select Start to upload the firmware.

Select Close when the process has completed or to terminate the process.

Passwords

Use the Password feature in the device configuration to change the current
password. This is the password that will be required when you access the device
through the RUI. The password file created is stored on the RTM device.

Note that only users with administrator access can change the RUI passwords.

For the administrator, enter a password in the Password field. Verify it by
entering it again in the Verify Password field.

Repeat for the user.

Select OK to confirm the passwords.

Device Reset

Selecting Reset Device resets the RTM device; it is equivalent to removing and
reinstating power. The configuration is reloaded from non-volatile RAM; any
configuration settings applied in the preceding few seconds may not be saved so if
you have changed settings wait a few seconds before resetting the box. The device
configuration is reloaded from non-volatile RAM upon restart.