Toshiba WLT66 - Manual (Page 35)

Below are the answers to some of the most common queries.
For more information go to www.toshiba.co.uk
A
Check the mains switch is on and check all mains
connections.
Check the television is not in standby mode.
Why is there no sound or picture?
Q
A
Check the volume has not been turned down or
that sound mute has not been selected.
Why is there a picture but no sound?
Q
A
Check that Panel lock is not ON.
Why don’t the controls on the front of the
television work? Q
A
Check all lead connections.
Why is there a good video picture but no sound?
Q
A
Make sure the VCR or DVD player is connected to
the television as shown on page 6, then select the
correct input by pressing B .
Why doesn’t the video/DVD being played show
on screen? Q
A
Check the correct input has been chosen,
S-VIDEO
or AV. See AV connections page.
Why is the VCR/DVD picture in black and
white? Q
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be achieved. The
colour is factory set to Auto. to automatically display the
best colour system.
To check that you have the best colour:
There is a picture, but why is there little or no
colour? Q
With the external source playing, select Manual
setting
from the SET UP menu.
With P or Q choose between Auto., PAL,
SECAM, NTSC 4. 43
or 3. 58.
1
2
?
For television
operation queries,
please ring the
helpline…
Remember…
Q
uestions
and
A
nswers
35
Select the Manual tuning menu. Highlight the
station and press OK, then press
R to select
Manual fine tuning .
Using P or Q adjust to get the best picture and
sound. Press OK and then EXIT.
1
2
A
Interference or a weak signal. Try a different
television station. Manual fine tuning may help.
What else can cause a poor analogue picture?
Q
A
Check the side switch on the remote control is in
TV mode.
Check the batteries aren’t dead or inserted incorrectly.
Why doesn’t the remote control work?
Q
A
Remove it by pressing .
Why is there a message permanently on the
screen? Q
Manual setting
Colour system: Auto.
EXT2 A V C R
OK Store
MENU Back EXIT Watch TV Manual tuning
Manual fine tuning
1 I A C 22 +2 B B C 1
OK Store
MENU Back EXIT Watch TV
i +
A
The signal strength may be too strong. Set the
Antenna Amplifier
option in the SET UP menu
to On.
Why is there picture and sound interference on
all digital and analogue channels? Q
g g