Toshiba B-450-QQ - Manual (Page 15)

8-2
EO1-33006
8. LOADING THE PAPER
8. LOADING THE PAPER
3. Put the paper roll and supply holders on the supply holder unit.
NOTE: Paper may be wound outside or inside. Regardless of the paper roll, the paper must be loaded
so that the print side faces upward.
Fig. 8-5
Paper Roll
Supply Holder
Paper Guide
Paper Guide Lock Lever
Supply Holder Guide
Lock Lever
4. Push both sides of the supply holder guides against the paper roll, then lock them with the lock lever.
NOTE: Make sure that the supply holders rotate slightly.
5. Pass the paper through the printer until it is past the paper outlet.
6. Adjust the position of the paper guides to the paper width, then lock them with the lock lever.
Fig. 8-4
Paper wound inside. Paper wound outside.
7. Close the print head block by pressing both sides of the print head block’s top until it clicks.
Fig. 8-6
Head Block